Mon Ster 40 Amp Controller With 3-Prong Connector For Jazzy Power Chairs With The GC Joystick Remote (Used)

It can be infuriating when an electronic component in your power chair goes haywire. It usually means paying more to get it fixed, whereas other repairs are typically not so costly. Monster Scooter Parts has procured a used 40 amp controller for the Jazzy Select, Select 6, and Select 6 Ultra power chairs fits selected units of those models. Now you can get a new power chair “brain” with a savings of over $125. The controller you see was tested on a fully functional Jazzy Select power chair, then cleaned and now it’s ready to ship to you.

This model is used exclusively with the GC joystick with the 3-prong connector. Please reference the notes below and the Compatibility tab for more information. However, if your power chair uses the GC joystick remote with a 3-prong connector, this is the correct matching controller.

Note for the Jazzy Select: This controller is applicable to Jazzy Select units manufactured prior to serial number J8307807126C30 and J8308607001C30 through J8310007045C30. Please note that some units manufactured within this serial number range may contain the Version 2 Electronics Assembly, ELEASMB5406.

Note for the Jazzy Select 6 and Select 6 Ultra: Applicable to all units equipped with GC electronics, serial numbers prior to J9226708001C30. These electronics are compatible with the GC/GC2 motors and only compatible with the GC joystick.

⚠ WARNING California Residents: Proposition 65 Warning